Home EV Charger Installation in London: A Homeowner's Guide

A home EV charger in London comes down to three questions: where your car parks, whether your electrical supply can carry the load, and whether the installation is certified and notified correctly. If you have a driveway or garage, the job is usually straightforward. If you park on the street, 2026 brought the biggest change in years. This guide covers both, so you can plan the work before you book it, and fold it into any wider electrical or refurbishment work at your property.
Our own experience is in London refurbishment and electrical work, so we look at the charger as part of the whole property: consumer unit, cable routes, finishes and paperwork.
TL;DR
Off-street parking makes a home charger simple. Street parking needs a council-approved cross-pavement solution, never a cable across the footway.
Most home chargers run at up to 7kW on a single-phase supply. A survey should check your main fuse and consumer unit before any contract is signed.
New permitted development rights for cross-pavement charging took effect in England on 21 October 2026, but highways permissions still apply.
Grants of up to £500 exist for flats, renters, landlords and on-street parking, funded until 31 March 2027. Check eligibility before you buy.
Keep the certification, testing record and warranty paperwork. You will need them for future electrical work and when you sell.
Table of Contents
Start with where the car parks
Before thinking about brands or power ratings, decide where the charger will physically sit and where the cable will run. In London this is the question that most often decides how simple the project is.
Driveway, garage or forecourt
If you park on your own land, the process is the familiar one. A charger is mounted on an outside wall, a garage wall or a post, with a dedicated cable run back to your consumer unit (the fuse board).

Planning permission is generally not needed for a home chargepoint, according to consumer guidance from the Renewable Energy Consumer Code’s sector body. The exceptions are an installation near a highway, a listed building, a ground-mounted unit over 1.6m high, or a wall-mounted unit over 0.2 cubic metres. Flat dwellers may need landlord permission.
London adds a layer. Haringey Council’s planning advice note says a driveway charging point is permitted development if it does not exceed 0.2 cubic metres or face within 2 metres of a highway, and that conservation areas may need planning permission. Large parts of Kensington, Chelsea, Notting Hill and Chiswick are conservation areas, so check yours before you fix anything to a front elevation. Our guide to permitted development rules in the UK explains the principle behind these limits.
Street parking
Many West London terraces and mansion blocks have no off-street space. The rule here has not changed: under the Highways Act 1980, it is illegal to run a cable across a public highway. That includes the pavement, even with cable protectors or drainage channels. The reason is practical: a trailing cable is a trip hazard, and the homeowner can be held responsible if someone is injured. It also blocks the footway for people with disabilities.
The lawful alternative is a cross-pavement solution, a channel set into the footway, approved by the local authority. London Councils’ July 2025 report on cross-footway charging sets out the site criteria:
the site is on a public highway and the resident has no off-street parking;
there is a suitable on-street space without restrictions;
there is at least 2.5m between the installation and any metal object connected to an electricity supply;
a local authority approved cross-footway solution with certified EV equipment is used.
What changed in October 2026
Until recently, a cross-pavement solution could need up to three separate permissions: Highways Act 1980 section 178 consent, planning permission and street works permission, as the Department for Transport’s government response explains.
From 21 October 2026, new permitted development rights in England allow a cross-pavement solution and its charge point to be installed without a planning application when fitted together. The Highways Act permissions remain, so your council still oversees the work. The aim, per the government response, is fairer access to home charging and a safer alternative to trailing cables.
The rights come with limits. Cornwall Council’s guidance notes they apply only where the chargepoint is part of an approved local authority cross-pavement channel scheme, and do not allow channels in conservation areas or the curtilage of listed buildings. Because the rule is national, the same limits apply in London. In a conservation area, speak to your borough’s planning team before you commit.
Check your electrical supply
The charger is the easy part. The supply behind it decides cost and timing.
Power rating and phases
Most home chargers are rated at 7.4kW (32A), which needs a 230V single-phase supply and a dedicated 32A circuit, as Homebuilding & Renovating reports. Government minimum technical specification for residential chargepoints describes standard AC outlets as 230V single-phase, with output above 3.5kW and up to 7kW. It also requires an on-site three-year warranty on parts and installation for equipment supported through the grant schemes.
A typical London house has a single-phase supply, and that is enough for overnight charging. A faster, three-phase connection is rarely needed for a home.
The consumer unit and main fuse
A survey should look at your main fuse, the condition and spare capacity of the consumer unit, how the charger will be isolated and protected, and how the cable will be routed. An older board may need replacing or an additional consumer unit, for example in a garage. If you are already thinking about the wider electrical picture, these installation tips at the electrical panel are a helpful companion for understanding capacity and earthing, and our piece on electrical solutions for home renovations shows how this fits into a bigger project.
Standards the installation must meet
The standard for electrical installations in the UK is BS 7671, the wiring regulations. The Institution of Engineering and Technology (IET) states that each AC charging point needs its own RCD (a device that cuts power in a fault) of at least Type A, with a residual operating current no higher than 30 mA. The socket outlet must sit 0.75 to 1.2m above finished floor level, and RCDs should be tested at six-monthly intervals with the test button.
For these reasons the fitting is a job for a qualified electrician who will test and certify it. It is not a weekend project.
What a proper installation involves
The Electric Vehicle Consumer Code for Home Chargepoints sets out good practice, and it is a useful yardstick for what you should expect.
A site survey before you sign. The code requires a pre-sale survey and a Maximum Demand calculation of your supply (how much load the property can safely draw) before any contract is signed.
A clear explanation of any supply problem. If the assessment finds an issue, the installer must explain what action is needed, which may include uprating the incoming supply, and the likely costs and benefits, so you can decide whether to go ahead.
A dedicated circuit. The final installation must comply with Part P of the Building Regulations, the IET Code of Practice and BS 7671, with a separate dedicated final circuit protected by a suitable RCD. Our overview of building regulations for West London homeowners explains why Part P matters for any domestic electrical work.
Notification to the network operator. The installer must notify your district network operator (DNO), and for a second chargepoint at the same home, give the combined current, such as 2 × 16A = 32A, according to the same consumer guidance.
A proper handover. You should receive confirmation of testing, an explanation of scheduling and safety features, electrical certification and fault guidance, as this installation guide advises. Keep the paperwork for warranties, a future sale and later electrical work.
The code also prohibits pressure-selling, such as inflated-then-discounted pricing or false claims that grants are about to run out, so a straightforward written quote is what you should expect.
Smart charging rules you will notice
Any private charge point sold in Great Britain for home use must have smart functionality under the Electric Vehicles (Smart Charge Points) Regulations 2021, in force since 30 June 2022. It must respond to signals to change the charge rate, keep charging if the network connection drops, and include safety provisions and a measuring system.
The regulations also require pre-set default charging hours outside peak times. Peak is defined as 8am to 11am and 4pm to 10pm on weekdays. You can accept, change or override those settings, so you stay in control of when the car charges.
Costs and grants
There is no single London price. The total depends on the charger itself, the cable run from the consumer unit, any consumer unit work, and whether the supply needs attention. A survey and an itemised written quote are the reliable way to find your figure, and the consumer code above is designed to make that quote clear.
On grants, the picture is specific. GOV.UK guidance of 25 February 2026 says that from 1 April 2026 the maximum grant rate for residents and landlords rose from £350 to £500 per socket. Funding for the flats and renters grant, the residential landlord grant and the on-street parking grant is confirmed until 31 March 2027.
For households without private off-street parking, the on-street parking grant offers 75% off, up to £500, when the chargepoint is installed with a cross-pavement solution such as a cable channel. You need local highways authority consent and adequate on-street parking. Temporary solutions like cable covers or mats do not qualify.

These schemes are aimed at flats, renters, landlords and on-street parking, so check the eligibility rules on GOV.UK before you order anything. Funding windows move, so confirm the current position on the official page.
Planning the charger into wider work
The cheapest moment to prepare for a charger is when walls, floors and the electrical system are already open. If you are planning a refurbishment, extension or loft conversion, think ahead:
Consumer unit capacity. A new or upgraded board can be sized with a charger circuit in mind.
Cable routes. Running a conduit to the front or side of the house before plastering or landscaping avoids chasing finished walls.
Location. Think about where the car will actually park, the socket height, and weather exposure.
Conservation area limits. Check front-elevation rules before the design is fixed.
Scaffolding and access. If external work is happening anyway, our guide to scaffolding costs, licences and access in London shows what that involves.
It is a sensible way to avoid paying twice for the same disruption.
Our perspective
We approach a home charger the way we approach every job on a London property: as part of the whole building. The charger is a small box on a wall. What makes it safe and long-lasting is the electrical system behind it, the route the cable takes and the paperwork you are handed at the end. That is why we like to see electrical upgrades planned alongside other work. Our in-house team handles electrical, plumbing and carpentry under director oversight, so the people who open up your walls are the people who plan the circuits that go into them. Our approach to quotes is the same whatever the job: fixed, itemised after a site survey, with no surprises. Ask any contractor for the same on a charger. A survey first and a written explanation of anything the supply needs is the standard worth holding to. Mateja
If you are refurbishing in West London
If an EV charger is one item on a longer list, our team can look at your electrics as part of the whole project. We carry out electrical work, plumbing and electrical repairs and general property maintenance for homeowners across Fulham, Chelsea, Kensington, Chiswick, Hammersmith and Notting Hill. For a larger project, our full property refurbishment service brings the work under one in-house project manager. Tell us about your property and we will arrange a site visit.
FAQ
Do I need planning permission for a home EV charger in London?
Usually not on a driveway. Permission is generally needed only near a highway, on a listed building, or above the size limits for wall or ground-mounted units. Conservation areas, which cover much of West London, may need permission. Check with your borough first.
Can I run a charging cable across the pavement?
No. The Highways Act 1980 makes it illegal, even with a cable protector. Since 21 October 2026 in England, a council-approved cross-pavement channel and charge point fitted together can go ahead without a planning application. Highways permissions are still required.
What power supply do I need?
Most homes use a 7.4kW charger on a single-phase supply with a dedicated 32A circuit. A survey should check your main fuse and consumer unit before you commit, and the installer must notify your network operator.
Is there a grant for a home charger?
Possibly. The maximum grant rate for residents and landlords is £500 per socket from 1 April 2026, with funding confirmed until 31 March 2027. The schemes target flats, renters, landlords and on-street parking, so check your eligibility on GOV.UK.
What paperwork should I receive?
You should get electrical certification, confirmation of testing, an explanation of the safety and scheduling features, and fault guidance. Keep them for warranties, any future electrical work and the sale of the property.
Sources
Cross-footway solutions for electric vehicle infrastructure, London Councils
Changes to various permitted development rights for EV charging, government response
Electric Vehicle Chargepoint Grant for Households with On-Street Parking
What you need to know before installing an EV charger at home, Homebuilding
Residential chargepoints: minimum technical specification, GOV.UK
The Electric Vehicles (Smart Charge Points) Regulations 2021, regulation 10
Changes to electric vehicle chargepoint grant schemes from 1 April 2026, GOV.UK
Recommended

Comments